· Latest computer technology.
· Ultimate reliability.
· Completely accurate.
· Easy to set-up.
· Semi or fully automatic operation.
· Robust construction.
· Single or three phase versions.
Based upon the latest technology in electronic control, the Teco roll-a-motor control units use the same processor as found in personal computers. Ultimate reliability combined with speed and accuracy to give completely repeatable torque control of the motor. This latest technolgy enables very easy initial set up is therefore quick and easy with no special skills required by the operator. Securely housed in an aluminium casing this control unit is properly engineered to withstand the rigours of workshop and site environment alike.
SELECTION GUIDE: ROLL-A-MOTOR CONTROL UNIT
110 or 230 : 1 phase : 50/60 Hz
220 or 400 : 3 phase : 50/60 Hz
Transformer to 42 volts
· Remote control (24 volts).
Digital read-out for programming.
Digital read-out for torque.
Reverse time setting 0 to 60 seconds.
Interval time setting 0 to 60 seconds.
Automatic phase corrector for 3 phase models.
Flat panel, easy clean push buttons.
· RS 232 connector for interface with
PC for read-out.